Dahon BoostOWNER’S MANUAL
Insert the battery into the battery-hanger unit until it clicks.Remove the battery lock key.10
Charging with Installed BatteryIt is possible to charge the battery installed on the bicycle as shown below.The charging method is the same as for cha
Your Dahon Boost comes standard with 2 battery lock keys; we suggest you keep one in a safe place for emergencies. Dahon Boost bike keys may be duplic
Range for BatteryRunning distance on one charge varies depending on rider’s weight, wind resistance, outdoor temperature, terrain, etc. Riders can exp
charging, use the battery until one red indicating lamp for the remaining battery charge is lit, and then store the battery again.It is recommended to
1. On-Off ButtonsGently press the ON button to activate the • unit. The Battery level lights will ash for several seconds before becoming xed at the
Normal Mode• : (Indicated by both the left-hand and middle lamps being lit) The Normal mode will also provide assis-tance up to 15kmh, bu
General OperationWhen you rst turn on the unit, make sure • there is no pressure on the pedals. Pres-sure or movement of the pedals affects the torqu
ServiceYour Dahon Boost will require the standard service requirements that are found in the bicycle manual. Please refer to instruction manual.Checkl
Initial inspection after 2 monthsApproximately two months after your rst • use, you should check to make sure every-thing is tight and secure.Inspect
ContentsWelcome/Intro ... 3What’s it called ...
TroubleshootingSymptom Please Check SolutionWhen riding the bikeThe pedals feel stiff.Are the indicator lamps on the controller lit? Set the control-
Symptom Please Check SolutionWhen riding the bikeShort Possible Riding DistanceHas the battery been charged? Set the control-switch to ONHas the batt
Symptom Please Check SolutionWhen chargingThe charging plug cannot be inserted into the battery connectorIs the orientation of the charging plug corre
SpecicationsMotor UnitType of Motor: DC Brushless.• Maximum Output: 250 W• Weight: 3,2kgs• Ambient Temperate for use: 0°C to 40°C• Ambient Temperate
Required assembly when Purchased.An Authorized Dahon Dealer is required to assemble your Dahon brand electric vehicle, without charge, at the time of
Notes25
Notes26
Notes27
© 2009 DAHON, BPSA2009.09.ENDahon California INC.833 Meridian StreetDuarte CA 910101-800-442-3511www.dahon.comDahon TW8F-8, #6, Lane 609, Chung Hsin R
Completely read through all of the • information in this manual before you start using you Dahon Boost.Make sure to read the standard Dahon • Bicycle
What’s it calledA. GENERAL 1. Assist Unit2. Chainwheel and integrated Torque sensor3. Battery4. Frame Latch5. Handlepost6. Handlebar Assembl
C. BATTERY AND CHARGER 1. Battery2. Boost Batter Charger3. Power Source Plug4. Battery Charging Socket5. Charger Plug5
Charging can be done when the battery is on the bike or removed from it. For details, refer to “Normal Charging” and “Charging with installed battery”
If the battery is wet or dirty, wipe it clean with a dry cloth.Insert the power plug into a power outlet.Insert the charging plug into the battery7
Indicating lamps of the battery chargerLamp(s) Illuminated StatusGreen (solid)Green (solid)Green (solid)Orange (solid)Green (solid)Green (blinking)Gre
Remove the charging plug from the battery when both indicating lamps change to green • indicating charging is completed. Remove the power plug from th
Commentaires sur ces manuels